Ordering is easy, just send me an email to [email protected] and I’ll get back to you as soon as possible. You can also use the contact form.
Keep in mind that since you are ordering a custom made strap, it should fit your wrist like a glove.
I will need these measures from you:
A – length of the long and the short piece of the strap
B – position of the hole you usually use, measured from the lug end to the hole
C – the width of the buckle tang(this is needed only if you plan to use your own buckle)
D – width of the strap(D2 if you would like it tapered)
That gives you the option to precisely position the buckle on your wrist. You can position it opposite of your watch, maybe a bit to closer to the inner side of the wrist, outer side…it all depends on your preference. You can also determine how long the tail(end of the longer piece of the strap) should be. Some like it to peep just a bit after it comes out of the keeper, some like it longer…again, it’s all up to you.
I know all of this sounds a bit complicated and overthought but after all, it’s a custom made strap.
If you are unsure about the length, check this out:
6.0 – 6.5″ wrist (150 – 164mm) = 120/70
6.6 – 7.0″ wrist (165 – 178mm) = 125/75
7.1 – 7.5″ wrist (179 – 190mm) = 130/80
7.6 – 8.0″ wrist (191 – 203mm) = 135/80
8.1 – 8.5″ wrist (204 – 216mm) = 140/85
8.6 – 9.0″ wrist (217 – 229mm) = 145/90
The cost depends on the strap, what leather is used, how complicated is to make it.
Shipping is free all over the universe
And buckles are included if I have one in the desired width.